Fr4000 Pa Replacement - Icom IC-FR4000 Service Manual

FR4000 PA Replacement

1. Remove old PA Board from FR4000. The new PA kit part number is 98415323.
2. See the following image. Verify there are 2 little shields, one big shield panel, one brick
final, and the PA Board. The power cable is not required...you already have one.
3. Put the PA Board in place and screw it into place firmly into the repeater.
4. See the following image. Put transistor grease on bottom of shield where it contacts the
chassis and put it in place. Solder the bottom shield onto the PA board.
Note: Board is shown outside of repeater for clarity.
©2008 Icom America Inc.
Page 1
Icom America, Inc.
2380 116 th Ave NE
Bellevue, WA 98004
425.540.6087