Fujitsu ETERNUS DX60 S3 Configuration Manual page 53

Chapter 4 Connecting Cables
4.4 Power Cord Connection
To help with power cord management and prevent incorrect connections, attach labels to the power cords
and make a note of connection origins and destinations.
1
Remove the power cord clamp from the power distribution unit.
Loosen the two thumb screws on both sides of the power cord clamp to remove it.
2
Connect the power distribution unit outlets and power supply unit inlets with the power cords (AC out-
put cables).
The procedures to connect the power supply unit is same as
tion Units are Installed" (page
Connect the PSU#0 power cord to power distribution unit#0 (the lower power distribution unit). Con-
nect the PSU#1 power cord to power distribution unit#1 (the higher power distribution unit).
The following figures show a connection diagram of AC outlet cables.
PSU#0 Inlet
Power cord clamp
50).
PSU#1 Inlet
Drive enclosure 1
Controller enclosure
PSU#0 Inlet PSU#1 Inlet
: Connect OUTPUT#0-n of the Power distribution unit to the PSU#0 inlet of the ETERNUS DX.
: Connect OUTPUT#1-n of the Power distribution unit to the PSU#1 inlet of the ETERNUS DX.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Step 1 in
Power distribution unit #1
Power distribution unit #0
53
"4.4.1 When No Power Distribu-
P3AM-9002-01ENZ0