Fujitsu ETERNUS DX60 S3 Configuration Manual page 27

Chapter 2 Rack Installation
2.1 Installing Power Distribution Unit (for Regions Other than EMEA&I)
3
Install the power distribution unit in the rack.
Fasten the power distribution unit to the bracket with the two M3 screws removed in
M3 screw
(Rack pillar: rear)
4
Attach the blank panel to the front side of the rack.
The blank panel should be attached at the same height as the power distribution unit.
Power distribution unit
(Rack pillar: rear)
M3 screw
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Blank panel
(Rack pillar: front)
27
Step 1.
P3AM-9002-01ENZ0