Chapter 10
System Status Check
10.6
Powering Off
■
When Controlling by the Power Switch
This section explains how to use the Power switch to turn off the ETERNUS DX.
1
Press and hold the Power switch of the controller enclosure for four seconds or more.
Power switch
The READY LED ( ) is turned off.
After power-off, wait for about one minute before turning power on again.
•
•
If the Power switch is pressed again between the time of the READY LED (
POWER LED (
2
The ETERNUS DX power is turned off.
The POWER LED ( ) is turned off.
■
When a Power Synchronized Unit is Used
If the server is turned off, the ETERNUS DX is also turned off.
) turning off, the ETERNUS DX power may turn on.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
151
) turning off and the
P3AM-9002-01ENZ0