Fujitsu ETERNUS DX60 S3 Configuration Manual page 32

Chapter 2 Rack Installation
2.2 Controller Enclosure Installation (for Regions Other than EMEA&I)
4
Install the controller enclosure in the rack.
5
Fasten the controller enclosure in the rack.
Use three M5 screws to fasten it in the rack pillar.
M5 screw
6
Attach the flange cover.
Do
When installing or removing the controller enclosure to or from the rack,
•
make sure that the sides and the bottom of the controller enclosure are held
by two or more people. Failure to do so may cause injury.
M5 screws
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
32
P3AM-9002-01ENZ0