Fujitsu ETERNUS DX60 S3 Configuration Manual page 125

Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
■
When Checking Using the ETERNUS Multipath Driver
The following procedure explains how to check LUNs with the ETERNUS Multipath Driver.
1
Click the [Start] button, expand [ETERNUS Multipath Driver] from [All Programs], and open [ETERNUS
Multipath Manager].
2
Confirm that the same number of LUNs are displayed as the number of LUNs that are set.
If the LUNs for the ETERNUS DX storage systems are recognized by the server, the devices (LUNs) in the
ETERNUS DX storage systems are displayed under LUN and Disk Number.
The host interface (CA) numbers of the ETERNUS DX are displayed on ETERNUS Multipath Driver as
shown below.
CM#0 CA#0 Port#0 g CAID = 00
CM#0 CA#0 Port#1 g CAID = 01
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
CM#1 CA#0 Port#0 g CAID = 02
CM#1 CA#0 Port#1 g CAID = 03
125
P3AM-9002-01ENZ0