Escort 3136A Operation Manual page 12

Rear Panel
The rear panel (shown in Figure 2-2) contains a line fuse, the power-line
cord connector, an RS-232 interface connector, and a cutout for
IEEE-488 interface (optional) connector.
Line Power
Figure 2-2 illustrates the location of the Line Voltage Selector with
Fuse Holder housing. If user has already done so, plug the line cord
into the connector on the rear of the meter. The meter will operate at
any line voltage between 90Vac and 264Vac when "line voltage
selector" is set properly, and its frequency range is at 50/60Hz. For
operation safety, DO NOT APPLIES a line voltage that exceeds the
range specified to line cord connector on the rear panel of the meter.
Power-Line Cord Connector
Earth Ground Terminal Screw
16VA 50-60Hz
~LINE VOLTAGE FUSE
Line Voltage Selector with
Fuse Holder Housing
*Available with IEEE-488 Interface Option only.
Otherwise covered with Plastic Decal.
BEFORE TURNING THE METER ON, MAKE SURE THE LINE VOLTAGE
SELECTOR IS SET TO THE CORRECT POSITION FOR APPLIED LINE
VOLTAGE TO THE POWER-LINE CORD CONNECTOR.
RS-232 Connector
WARNING
Line Voltage Fuse
Selection Table
Figure 2-2. Rear Panel
CAUTION!
8
IEEE-488 I/F Connector *
GPIB
RS-232C
Real Panel
Protective Holster