Table of Contents
Advertisement
EJECTOR SPRING
TRIGGER ASSEMBLY
Figure 5-18
Diskette Ejector Assembly Key Parts
D. Lift up the Bridge Assembly approximately two inches, taking care not to pull the L.
E.
D.'s
from their sockets.
E.
Release the spring attached to the rear of the ejector.
F. Remove the ejector.
5.14.2
Installation
A. Insert the ejector.
B. Engage the spring attached to the rear of the ejector.
C. Insert the Bridge Assembly approximately two inches, taking care to put the L.
E.
D. 's in their
respective sockets.
D. Reinstall the original four screws that hold the Bridge Assembly.
E.
Push on the lever. Reinstall the retaining screw. Insert the small plug in the door lever.
F. Reinstall the circuit board (see Section 5.3.1).
5.14.3
Checks
A. Insert a work diskette into the drive.
B. Ensure that the diskette stays in prior to being closed.
C. Close and open the diskette lever.
D. The diskette should eject.
E.
If not, see Section 5.4.
5.15
LOAD RESISTOR ASSEMBLY
5-15
Advertisement
Table of Contents
