Table of Contents
Advertisement
5.5
DISKETTE LEVER
5.5.1
Removal
A. Pry off the cover that hides the diskette lever's retaining screw (see Figure 5-6).
MOUNTING SCREW
~"
COVER
DISKETTE LEVER
Figure 5-6
Diskette Lever Key Parts
B. Remove the diskette lever's retaining screw.
C. Carefully remove the diskette lever.
5.5.2
Installation
A. Put the diskette lever on the shaft.
B. Put a drop of Locktite Number 234 on the threads of the diskette lever's screw.
C. Install and tighten the diskette lever's screw.
D. Put the cover back on the diskette lever.
5.5.3
Checks
A. Ensure that the diskette lever is perpendicular to the drive when the diskette is clamped. See
Figure 5-7 for the adjustment.
. B. Ensure that the diskette lever is parallel to the drive when the diskette is unclampled. See
Figure 5-7 for the adjustment.
-
5.6
BRIDGE ASSEMBLY
5.6.1
Removal
A. Remove the circuit board (see Section 5.3.1).
B. Remove the diskette lever (see Section 5.5.1).
C. Remove the four bridge mounting screws that attach the Bridge Assembly to the chassis
(see) Figur 5-8).
5-6
Advertisement
Table of Contents
