Replacement Procedures; Introduction; Drive Belt - Tandon TM848-1 Operating And Service Manual

SECTION V
REPLACEMENT PROCEDURES
5
INTRODUCTION
This section contains the replacement procedures for the TM848 family of disk drives' parts and
assemblies:
'1. 0 rive Belt
2. Drive Motor
~3.
Circuit Board
4. Cone Assembly
!5. Diskette Lever
6. Bridge Assembly
7. Front Panel
8. Activity L. E. D.
9. Load Arm Assembly
10. Track 00 Sensor Assembly
1 "I. Write Protect Sensor Assembly
12. Door Switch Assembly
1
~3.
Index Sensor Assembly
14. Diskette Ejector Assembly
1 t5. Load Resistor Assembly
16. Stepper Band
17. Stepper Motor Assembly
18. Head Carriage Assembly
5.1 DRIVE BELT
5.1.1 Removal
A. Turn the drive over so that the spindle is facing upward (see Figure 5-1).
5-1