Activity L, E, D - Tandon TM848-1 Operating And Service Manual

5.7.2 Installation
A. Put the bezel on the drive, ensuring that the Activity L. E. D. goes into its holder.
B. Install the four bezel mounting screws that attach the bezel to the chassis.
5.7.3 Checks
A. Ensure that the Activity L. E. D. goes on when required.
B. Ensure that the diskette lever clamps the cone and loads the head.
5.8 ACTIVITY L. E. D.
5.8.1 Removal
A. Remove the bezel (see Section 5.7.1).
ACTIVITY LED.
(INSIDE)
ACTIVITY LIGHT WIRES
BRACKET
1 NEAR SIDE
TIE BRACKETS
2 FAR SIDE
J 0
o~
o
0
B. Remove the brackets that hold the bundle of wires going to P11 from the chassis (see Figure
5-11 ).
Figure 5-11
Activity L. E. D. Key Parts
C. Remove the Activity L. E. D. and its wires after unplugging P11.
5.8.2 Installation
A. Install the Activity L. E. D. into the bezel.
B. Install the bezel.
C. Attach the Activity L. E. D. wires to the chassis with brackets (see Figure 5-11).
D. Plug P11 into the circuit board.
5.8.3 Checks
A. Ensure that the Activity L. E. D. does not interfere with the drive mechanisms.
B. Ensure that the Activity L. E. D. goes on when required.
5-9