Table of Contents
Advertisement
o
TRACK 00
SENSOR
ASSEMBLY
BFIACKET -++-t---:;;~~~
Figure 5-13
Track 00 Sensor Assembly Key Parts
C. Remove the P2 wires from the bracket attached to the chassis.
D. Remove the two mounting screws that hold down the Track 00 Sensor Assembly.
E.
Lift off the Track 00 Sensor Assembly.
5.10.2
Installation
A. Using the two original mounting screws, install the Track 00 Sensor Assembly.
B. Loop the P2 wires from the Track 00 Sensor Assembly through the bracket attached to the
chassis.
C. Using tie wraps, cable harness the P2 wires and the other wires together.
D. Plug P2 into the circuit board.
5.10.3
Checks
A. Adjust the Track 00 sensor (see Section II).
5.11
5.11.1
WRITE PROTECT SENSOR ASSEMBLY
Removal
A. Remove P3 from the circuit board.
B. Remove the two mounting screws that attach the Write Protect Sensor Assembly to the
chassis (see Figure 5-14).
C. Cut the tie wraps that hold the wires to the cable harness, and lift out the Write Protect Sensor
Assembly.
5-11
Advertisement
Table of Contents
