Sending A Status Message; Sounding A Horn; Connecting A Printer; Encryption Function - Icom IC-F5060 Series Operating Manual

5
IDAS OPERATION

■ Sending a Status message

Status message can be automatically transmitted.
The status message is transmitted when:
• The transceiver is turned ON or OFF
- Set the status message to be transmitted in 'Power ON Status'
or 'Power OFF Status' item, respectively.
- Set the target station ID in 'Power Status ID'.
• A voice message is sent.
- Set the 'Send with Voice Call' item to 'Enable.'
- Set the status message to be transmitted in the 'Send Status
Number' item.

■ Sounding a Horn

An automatic honking function can be used if a horn is con-
nected to the D-Sub 25-pin connector of the transceiver.
When a status message is received, the transceiver honks
the vehicle's horn for the specified time period to indicate a
status message is has been received.
This function is convenient when the operator is away from
the transceiver.
Ask your dealer or system operator, or refer to the IC-F5061/
F6061 series service manual for connection and setting de-
tails.
45

■ Connecting a Printer

When a printer is connected to the D-sub 25-pin of the trans-
ceiver, the received SDM content and the caller station ID can
be printed out.
Ask your dealer or system operator for connection details.

■ Encryption function

The encryption function enables voice scrambling, which pro-
vides private digital communication between stations.
q Push [Scrambler/Encryption] to turn ON the encryption
function.
• " " appears.
w Push [Scrambler/Encryption] again to turn OFF the en-
cryption function.
• " " disappears.