Transmitting A Message - Icom IC-F5060 Series Operating Manual

D Transmitting a Message
The transceiver can send a preprogrammed message. There
are 16 messages that can be sent.
q Push [MDC Call] to enter the MDC menu selection mode.
w Push [CH Up] or [CH Down] to select "MSG".
M S G
e Push [MDC Call] again to enter the preprogrammed mes-
sage selection mode.
M S G
M S G 1
Preprogrammed message is displayed.
r Push [CH Up] or [CH Down] to select the desired mes-
sage.
t Push [PTT] to transmit the selected message.
• "MSG TX" is displayed.
y Release [PTT].
• "MSG OK" is displayed if the targeted station sends an acknowl-
edgement.
• "MSG FAIL" is displayed if the targeted station does not send an
acknowledgement.
u After a specified time period has passed, the transceiver
will return to receive.
MDC 1200 SYSTEM OPERATION
D PTTID Calls
The transceiver can send an MDC 1200 system signal that
includes PTTID when [PTT] is pushed (beginning of trans-
mission) and released (end of transmission). If a PTTID call is
received, the transceiver may display the calling station ID (or
alias) and emit a beep, depending on the presetting.
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
22