How To Display The Alert Log - Furuno FE-800 Operator's Manual

2.7.2

How to display the alert log

The [Alert Log] tracks all alerts.
1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using
3. Select [Alert] using
4. Select [Alert Log] using
230 Depth below Keel Alarm
101 TX Volt Error1
102 RX Volt Error1
103 TCVR High Temperature1
950 BAM COM Error
Note: The above example shows alerts which are output under Alert I/F1 or Legacy settings.
When the unit is using Alert I/F2 settings the alerts are output with the prefix "210".
For example "210301 DISP COM Error".
For more information about alert codes and meanings, see section 2.8.
Alert I/F1, Alert I/F2 and Legacy settings are set during the initial installation. Consult a
FURUNO technician to change these settings.
5. To change pages, use
6. Press the DISP key to close the open menus.
or , then press the ENT key.
or , then press the ENT key.
or , then press the ENT key.
Depth
or .
23
2. SYSTEM MENU
Page No.
Log entry