How To Set Or Adjust The Time; External Time - Furuno FE-800 Operator's Manual

2.9

How to Set or Adjust the Time

The unit can display the time from an external EPFS device (such as GPS), or the unit's internal
clock. The time source is selected during the initial installation and requires a FURUNO technician
to adjust the setting. The source which has not been selected at installation will be displayed as a
grey, unselectable menu item in the [Ship's Time] menu. The example below shows [External] as
the selected source, with [Internal] as unselectable (grey).
In configurations where the time source is set to [External] and the source signal is lost (for
example, the GPS fails), the unit reverts to the internal clock and the time is displayed in yellow.
2.9.1

External time

1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using
3. Select [Ship's Time] using
4. Select [External] using
5. Select [Time] or [Local Difference] as appropriate, using
will open a pop-up window.
Menu item
Time
Time Difference
Local Zone
6. Adjust the parameter using
the pop-up window. To keep the default setting, press the DISP key or the MENU/ESC key.
7. Press the MENU/ESC key four times to close the menu.
or , then press the ENT key.
or , then press the ENT key.
or , then press the ENT key.
Setting range
UTC (UTC Time difference)
Local (Ship's local time)
Auto or Manual
-13:45 to +13:45 (at 15 minute intervals)
or , then press the ENT key to apply the settings and close
27
2. SYSTEM MENU
or , then press the ENT key. This
Default
UTC
AUTO
0:00