Mercedes-Benz COMAND Operating Instructions Manual page 78

Destination input
76
To select a destination: press the con-
X
troller.
The list contains the
there are multiple destinations around the
crosshair, a selection list will also appear.
To show the menu: press the controller.
X
To select a destination from the selection
X
list: turn and press the controller.
If the digital map provides navigable
address data, you will see the destination
address in the address entry menu. If not,
the Destination from Map, Date_1, Destination from Map, Date_1,
Time_1entry is shown. Time_1
To start route calculation: select
X
Entering way points
Introduction
You can also map the route to the destination
yourself by entering up to four way points. The
sequence of the way points can be changed
at any time.
COMAND provides a selection of predefined
destinations in eight categories for this pur-
pose, e.g. GAS STATION GAS STATION
can also use the destination entry options to
enter way points.
Menu Menu menu item. If
Start. Start
or RESTAURANT. You RESTAURANT
Creating way points
To switch to navigation mode: press the
X
Ø button.
To show the menu: slide 6 the control-
X
ler.
To select Destination: turn and press the Destination
X
controller.
Select Way Way Points Points.
X
The destination is entered into the way
points menu. The way points are not yet
entered.
To select Add New: Add New:
X
To select a category or
X
press the controller.
After selecting a category, the POIs which
are available along the route and in the
vicinity are displayed.
COMAND first searches for destinations
along the route. The search for destinations
is then initiated in the area around the vehi-
cle position.
After selecting Other, select one of the Other
X
destination entry options from the list.
: press the controller.
Other: turn and Other