Flow Limiter - Biasi RIVA COMPACT M90E.24S Service Manual

2 Remove the flow switch sensor (see section
14.4).
3 Remove the gas valve (see section 11.6).
4 Unscrew the plug 2 (Fig. 57) and extract the flow
switch group.
5 To remove the filter from the flow switch group
separate the body 7 from the plug 2 (Fig. 57) by
unscrewing it.
6 Reassemble the parts following the removing se-
quence in reverse order.
Attention: the ring 3 (Fig. 57) has a magnetic polarity
and must be correctly coupled with the spindle of
the float 4.
To determine the correct orientation of the ring proceed
as follows:
1 Set the function selector of the boiler in stand---by
mode (Fig. 58).
Fig. 58
2 Restore the mains electricity supply to the boiler.
Waring -- ensure that all the electric parts and
wirings are dry and do not touch other not
mentioned electric parts during the following
operations.
3 Hold the flow switch sensor 1 and bring the ring
in touch with the sensor as illustrated in Fig. 59.
4 Observe the lamp B placed on the sensor body
that should light. If not reverse the ring and repeat
the previous operation.
D.h.w. flow switch, filter and flow limiter
5 Fit the ring on the spindle of the float in the way
that lights the lamp B.
6 Isolate the boiler from the mains electricity supply
and reassemble the parts following the removing
sequence in reverse order.
B
1
Fig. 59
14.6

Flow limiter

The M90E.24S model is factory fitted with a 10 litre/min.
flow limiter.
If on the M90E.28S model the flow rate of the d.h.w. cir-
cuit is too high, it is possible to limit it by installing a flow
limiter. The following sizes are available:
Nominal flow rate (litres/min)
10
12
To install the flow limiter:
1 Remove the flow switch group as explained in the
section 14.5.
2 Unscrew the threaded ring 10 (Fig. 57) and re-
move it from the body 7.
3 Install the flow limiter 9 putting its smaller diam-
eter side towards the threaded ring.
4 Reassemble the group following the above se-
quence in reverse order.
4
3
Colour
Yellow
Brown
31