H.w. Flow Switch, Filter And Flow Limiter; Function; Nomenclature And Location Of Parts; Checks - Biasi RIVA COMPACT M90E.24S Service Manual

14 D.h.w. flow switch, filter and flow
limiter
14.1

Function

The d.h.w. flow switch A in Fig. 55 is a device that gener-
ates an electrical signal when hot water is drawn.
Fig. 55
When the flow rate through the d.h.w. circuit reaches
about 2,5 litres/min', the float 4 (Fig. 57) is drawn to-
wards the right.
The resulting magnetic field of ring 3 increases and re-
aches the flow switch sensor 1.
The sensor generates an electrical signal that switches
the boiler d.h.w operation ON.
The state of the sensor is also indicated by means of the
lamp B placed on the sensor body.
Fig. 56
30
A
C B
14.2

Nomenclature and location of parts

(Fig. 57)
1 Flow switch sensor
2 Plug
3 Magnetic ring
4 Float
5 Spring
6 Filter
7 Body
8 Spring seat
9 Flow limiter (M90E.28S optional accessory)
10 Threaded ring
2
1
Fig. 57
14.3

Checks

Warning: isolate the boiler from the mains
electricity supply before removing any
covering or component.
Flow switch sensor operation
n
1 Remove the front panel of the case.
2 Switch on the boiler and open a d.h.w. tap. The
lamp B (Fig. 56) placed on the sensor body is
switched on when the flow rate reaches about 2,5
litres/min'.
14.4 Removal of the f
Warning: isolate the boiler from the mains
electricity supply before removing any
covering or component.
1 Remove the front panel of the case.
Disconnect the connector C (Fig. 56) and remove
2
the sensor by pulling it towards the front of the
boiler (the sensor is held in place by means of a
spring).
14.5 Removal of the flow switch group and
d.h.w. circuit filter
Warning: isolate the boiler from the mains
electricity supply before removing any
covering or component.
1 Remove the front panel of the case and empty the
d.h.w. circuit.
8
7
6
5
4
3
low switch sensor
10
9