H.w. Flow Switch, Filter And Flow Limiter; Function; Nomenclature And Location Of Parts; Checks - Biasi M110B.24SM/E Service Manual

Wall hung, fanflue, roomsealed, high efficiency gas boiler
Table of Contents

Advertisement

D.H.W. fLoW SWITCH, fILTER AND fLoW LIMITER
14
D.H.W. fLoW SWITCH, fILTER AND fLoW LIMITER

14.1 function

The d.h.w. flow switch A in Figure 14.1 is a device that generates
an electrical signal when hot water is drawn.
figure 14.1
When the flow rate through the d.h.w. circuit reaches about 2,5
litres/min', the float 5 (Figure 14.3) is dragged upwards and the
magnet in it, getting closer to the sensor 8, closes the electric
contact that switches the boiler d.h.w operation ON.
C
figure 14.2

14.2 Nomenclature and location of parts

- (figure 14.3)
1 Flow switch plug
2 O-ring
3 Flow limiter (optional for M96A.32SM/...)
4 Body
5 Float
6 Filter
7 Sensor holder spring
8 Sensor
A
D
B
2
1
3
4
5
6
figure 14.3

14.3 Checks

Warning: isolate the boiler from the mains electrici-
ty supply before removing any covering or compo-
nent.
Sensor operation
1 Remove the front panel of the case.
2 Measure the electrical resistance at the leads of the sensor.
Without water being drawn, the contact must be open. By
opening a hot water tap the contact must be close (electrical
resistance zero Ω).

14.4 Removal of the sensor

Warning: isolate the boiler from the mains electrici-
ty supply before removing any covering or compo-
nent.
1 Remove the front panel of the case.
2 Disconnect the connectors B and remove the sensor holder
spring 7 (Figure 14.2 - Figure 14.3).
3 Remove the sensor.
14.5 Removal of the flow switch group and d.h.w.
circuit filter
Warning: isolate the boiler from the mains electrici-
ty supply before removing any covering or compo-
nent.
1
Remove the front panel of the case and empty the d.h.w. circuit.
2 Remove the sensor (see section "Removal of the sensor"
page 31).
3 Remove the fork D and pull up the flow switch plug 1 (Figure
14.2 - Figure 14.3) with the help of a screwdriver.
4 To remove the filter from the flow switch group separate the
filter 6 from the body 4 (Figure 14.3) by levering it.
5 Reassemble the parts following the removing sequence in
reverse order.
8
7
- 31 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

M110b.32sm/e

Table of Contents