Initial Settings - Furuno RP-340 Operator's Manual

3 VIDEO PLOTTER
3.9

Initial Settings

Items displayed on the plotter display are usually set on the DISPLAY SELECT
menu. You can turn these items off from the VIDEO PLOTTER INITIAL
SETTING menu as below, and any item turned off will not appear on the
DISPLAY SELECT menu.
Note: Normally, the VIDEO PLOTTER INITIAL SETTING menu is not displayed.
To display it, press the [RADAR MENU] key five times while pressing and
holding down the [HL OFF] key. Then, follow the procedure below.
1. Press the [NAV MENU], [0] and [0] keys to show the VIDEO PLOTTER
INITIAL SETTING menu.
2. Press appropriate numeric key to turn item on or off as desired.
3. Press the [ENTER] key.
4. Repeat steps 2 and 3 to set the other items.
5. Press the [RADAR MENU] key to close the menu.
Only those items turned on in the above menu are displayed on the DISPLAY
SELECT menu (see page 15).
42
[VIDEO PLOTTER
INITIAL SETTING]
1 [VIDEO PLOTTER 2]
2 SYMBOL
OFF/ON
3 COAST LINE
OFF/ON
4 LAND DENSITY
OFF/ON
5 PLACE NAME
OFF/ON
6 MARK
OFF/ON
7 OWN SHIP PLOT
OFF/ON
8 TARGET PLOT
OFF/ON
9 CONTOUR LINE
OFF/ON
0 GRID
OFF/ON
Video plotter initial setting menu