Interlogix ZeroWire Installation Manual page 13

2. Align the ZeroWire to the top clips on the wall bracket, then slide the ZeroWire in to
place so it sits flat against the wall.
3. Use a screwdriver to tighten the screw you loosened previously.
You may enable the box tamper feature from the System Menu – General Options via the
ZeroWire Web Server. This will cause an alarm to occur if the ZeroWire is removed from
the wall.
If you do not wish to install the product on a wall, you may use the optional table bracket to
place the ZeroWire on a secure flat surface.
ZeroWire Installation Manual 7