Yamaha YSP-300 Owner's Manual page 95

Press _ / _ so that "TURN ON VOLUME" is
displayed in the front panel display.
VOL
iiiRii., nil., i nL iiiiEo
4 Press ENTER.
You can test the sound beam output from this unit to
experience the sound beam.
1 Repeat steps 1 to 3 in "Using the system
parameters" on page 88.
2 Set the operation mode selector to YSP.
3 Press _ / v so that "DEMO MODE" is
displayed in the front panel display.
5 Press <_/ _ to adjust the initial volume level.
"%:,
v°L lm
I% :"' :..I ,"= I, ,l ,", I% I.... ;
.,'....= i::-i:i Li i"i Li 7 i::- =
4
Press ENTER.
Control range: MAX, 99 to 01, OFF
Control step: 1
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
The new setting for the maximum volume level will
be activated when you turn on the power of this unit
next time.
91
En