Table of Contents
Advertisement
Basic Operations
Making a call
Make sure that the reception signal is sufficient and that at least one bar
is shown on the signal indicator.
1
Open the flip cover.
The backlight of the display will come on.
2
Enter the telephone number, including
the full area code.
If you make a mistake entering a number,
press the
is deleted, then enter the correct number. To
re-enter the whole telephone number from the
beginning, press the
correct number.
The telephone number can be a maximum of
32 digits in length. If the number exceeds 11
digits, the numbers will scroll to the left as
you enter additional numbers.
3
Press the
• The telephone number you entered scrolls
to the left and the phone dials the number.
While the number is being dialed, the tele-
phone number on the display blinks.
• After you are connected to the other party,
the amount of time connected is shown on
the display.
The connection time can be displayed for
up to 999 minutes 59 seconds. (The ac-
tual connection time may be different.)
• The connection time display on that ap-
pears on display when you are using the
phone is only a guide.
4
When you are finished calling, termi-
nate the connection.
Press the
key to terminate the connection.
The connection is terminated and the con-
nection time display stops. Pressing the
key again will clear the connection time dis-
play from the panel display.
8
R12-PHS_Body.pm6
key until the incorrect number
key then enter the
key.
Example:
Display after 1 min. 1
sec.
8
7/24/00, 2:16 PM
Advertisement
Table of Contents
