Charging The Battery - Kyocera R12T Owner's Manual

Getting Started

Charging the battery

Before using your phone for the first time, charge the battery for eight
hours.
1. Connect the AC adapter to a power source and insert the AC
adapter plug into the phone.
The battery mark on display will start to blink.
2. When the battery is fully charged, remove the AC adapter plug.
The battery mark on the phone display will blink while the phone is
charging, and then will be stop the blinking when the phone is fully
charged.
When the battery power is low, all of the bars of the battery mark will
disappear and only the frame around the battery mark will be shown. If
you are in a call, an alert tone is emitted to let you know the battery
power is low.
Recharge the battery before using the phone.
Notes:
• If you feel that the battery time is getting shorter, the battery may
be experiencing the memory effect. If this occurs, use the phone
until the battery is fully used all the bars of the battery mark disap-
pear and only the frame around the battery mark is lit. Then charge
the battery for 8 hours. This should restore the battery to its full
capacity again.
• Normally, the battery is very sensitive to the surrounding tem-
perature. Therefore, if you use the phone, or charge the battery, in
conditions where it is subject to extreme heat or cold, you may
not get the best performance from the battery.
4
R12-PHS_Body.pm6 4 7/24/00, 2:16 PM