Epson TM-C7500 Series Technical Reference Manual page 181

Media type
Media source
Backing paper width
Label width
Label length
Gap between labels
Left and right outer edges
Label edge R
Width of a black mark
Length of a black mark
Black mark position
Gaps between black marks
Paper thickness
Perforated line pitch
Form of perforated line
Number of folds
 Do not use the paper with a hole or cutout.
 Autocutting on the perforated lines may generate minute paper dust, causing machine prob-
lems. Also, autocutting ahead of the perforated line may cause problems when feeding
paper. Therefore, autocutting must be performed 0.5 mm to 1 mm {0.02 to 0.039"} behind
the perforated line.
 Therefore, set the black mark position 2 mm {0.08"} or more from the perforation.
 For the black mark position of the die-cut label paper, match the label edge to the black
mark edge.
 The perforations on both sides of the paper shall be uncut.
Plain label / Matte label
Fanfold paper
50 to 112 mm {1.97 to 4.41"}
46 to 108 mm {1.81 to 4.25"}
25.4 to 301.8 mm {1 to 11.88"}
3 to 6 mm {0.12 to 0.24"}
2 mm  0.5 mm {0.08  0.020"}
1.5 mm {0.06"} or less
28 mm {1.10"} or more from paper edge
5 mm {0.20"} or more
Right edge of back of paper, when feed edge is at top
28.4 to 304.8 mm {1.12 to 12.0"}
0.161 to 0.164 mm {0.006 to 0.006"} (reference value)
203.2 to 304.8 mm {8 to 12"}
1 mm {0.039"} uncut, 5 mm {0.20"} cut
750 or less
1 mm {
Perforated line
Length of the
uncut portion
} 1 mm {
0.04"
Length of the portion
Appendix
}
0.04"
181