Powerware 5115 User Manual page 48

Troubleshooting
Alarm or Condition
Continuous
beep.
3 beeps every 10
seconds.
Continuous
beep.
Continuous
beep.
42
Powerware
®
Possible Cause
UPS fan fault
(750–1400 VA models
only).
Failed attempt to start
the UPS on battery.
The output wave is
abnormal while the UPS
is on battery.
The output voltage is
below or above the limit
while the UPS is on
battery.
5115 Tower UPS (500–1400 VA) User's Guide
Action
Save your work and turn off your equipment.
Turn off the UPS. Contact your service
representative.
Plug the UPS into a power outlet for 24 hours to
charge the battery. After charging the battery,
press and hold the button for 3 seconds;
then check the indicator.
If the indicator still flashes, see "Replacing
Batteries" on page 30 to replace the battery.
Shutdown is imminent. Save your work and turn
off your equipment. Turn off the UPS. Contact
your service representative.
Save your work and turn off your equipment.
Turn off the UPS. Contact your service
representative.
05146640 Rev C www.powerware.com
S