Chapter 4 Operation; Turning The Ups On; Starting The Ups On Battery; Turning The Ups Off - Powerware 5115 User Manual

Chapter 4

Turning the UPS On

Turning the UPS Off

Powerware 5115 Tower UPS (500–1400 VA) User's Guide
®
Operation
This section describes:
Turning the UPS on and off

Starting the UPS on battery

Standby mode
The UPS front panel and indicators
Initiating the self-test
After the UPS is connected to a power outlet, the UPS enters Standby
mode. To turn on the UPS, press and hold the
the UPS beep (approximately two seconds). After the UPS is turned on, it
conducts a self-test and enters Normal mode. The
illuminates indicating that power is available from the UPS output
receptacles.
Starting the UPS on Battery
NOTE
The UPS does not auto-detect the input frequency when starting
on battery; the default is the last frequency used by the UPS.
To turn on the UPS without using utility power, press and hold the
button for two seconds. The UPS supplies power to your equipment
and goes into Battery mode. When the UPS starts on battery, it does not
conduct a self-test to conserve battery power.
To turn off the UPS, press and hold the
then unplug the UPS from the power outlet. If you do not unplug the
UPS, it remains in Standby mode.
button for two seconds and
05146640 Rev C www.powerware.com
S
button until you hear
µ
indicator
23