Using Feed Mode - Brother DH4-B981 Instruction Manual

7. SEWING

7-7. Using feed mode

In this mode, the feed bracket and the work clamp can be moved while the needle is stopped.
It is useful for checking the relative positions of the throat plate and the work clamp. However, the buttonhole length
cannot be changed.
r
w
0942Q
1. Turn off the power.
2. Set DIP switch C q No. 1 and No. 2 on the control circuit board to ON and OFF respectively.
3. Turn on the power.
3. * "FE" will appear to indicate feed mode.
4. Press the start switch w.
* The feed bracket e will move to the cloth setting position.
4.
5. Press the cloth presser switch r. The work clamp will be lowered.
6. Press the start switch w.
* The feed bracket e will move to the sewing start position.
6.
* When the start switch w is pressed, the feed bracket e will move to the next sewing start position.
6.
* To return the feed bracket e to the cloth setting position while sewing:
6.
1) Press the EMERGENCY STOP switch t.
6. *
2) Press the RESET switch y.
6. *
6. * 2) NOTE: The knife will not operate during this time.
48
t
e
y
DH4-B981
C
1 2 3 4 5 6 7 8
OFF
q
0943Q