Setting The Number Of Eyelet Buttonholes (-52 Specifications); Setting The Number Of Home Position Start Cycles - Brother DH4-B981 Instruction Manual

6. USING THE OPERATION PANEL
L. Setting the number of eyelet buttonholes (-52 specifications)
C
1 2 3 4 5 6 7 8
OFF

6-5. Setting the number of home position start cycles

You can set the number of home position start cycles as a method of reducing the cycle time.
q
38
No. 7 No. 8 Number of eyelet buttonholes
ON
3
OFF
4
OFF OFF
ON
5
OFF
ON ON
6
1. Turn off the power.
2. The setting range for the number of eyelet buttonholes
2. for a single piece of cloth (fly) is 3 - 6 holes.
2. Setting is possible when the cloth feed bar is at the left
2. setting position.
3. Change the settings for panel DIP switch C No. 7 and
3. No. 8 to set the desired number of eyelet buttonholes.
4. Turn on the power.
NOTE:
4. When changing the number of eyelet buttonholes,
4. change the installation position of cloth feed plate (L).
0919Q
4. (Refer to page 30.)
1. While pressing the RESET switch q, turn on the power.
2. Press the "Up" switch w or the "Down" switch e to set
2. the number of home position start cycles in the number
display window r. The setting range is 0 - 9 and A.)
2.
2. * If the number of home position start cycles is set to
2. * "5", home position starting will occur once for each
r
2. * five sewing operations (for -52 specifications, once
2. * for each five pieces of cloth (fly)).
2. * If the number of home position start cycles is set to
2. * "0", home position starting will not be carried out.
2. * If the number of home position start cycles is set to
w
2. * "A", home position starting will be carried out for each
2. * hole.
e
3. Press the start switch to accept the new setting for the
3. number of home position start cycles. The machine
0920Q
3. will then switch to the normal standby condition ("--"
3. will appear on the display).
NOTE:
3. If home position starting is not carried out for each
3. piece of material, there is the danger that the feed
3. bracket may become overloaded for some reason and
3. come off, which will affect the next piece to be sewn.
3. Accordingly, it is recommended that you set the home
3. position starting to be carried out each time ("HA"
3. displayed).
DH4-B981