Brother DH4-B981 Instruction Manual page 26

3. INSTALLATION
3-20-5. Connecting the connectors
8
w
t
e
P21-EXOUT
u
i
o
20
0802Q
9
10
q
t
P21 EXOUT
r
y
0853Q
0854Q
DH4-B981
1. Insert the 3-pin connectors ,, . and ⁄0 of the valve
harness into the solenoid valves of the valve unit q so
that the label numbers match.
2. Insert the 15-pin connector w into the connector of the
indexer cord e.
3. Open the rear cover t of the control box.
4. Insert the connector t of the indexer cord e in the
position shown in the illustration.
5. Secure the cord with the cord clamp.
6. Insert the two pins of limit switch (R) y and the two
pins of limit switch (L) u into the 15-pin connector
terminals with matching numbers.
7. Connect the three pins of the cylinder sensor i into
the 15-pin connector so that the cable colors match
the connector numbers as given in the table below.
* If the cable colors are red, white and black, refer to
the colors in brackets.
NOTE:
First disconnect the connector before inserting the pins,
and then after inserting the pins, re-connect the
connector.
Switch pin No.
7
Limit switch (R) y
12
10
Limit switch (L) u
15
Cylinder sensor i
8. Secure the cable with the cable clamp o.
Cable color 15-pin Connector
White 7
Black 12
White 10
Black 15
Brown (Red) 4
Black (White) 9
Blue (Black) 14