Using Test Feed Mode - Brother RH-981A Instruction Manual

7-7. Using test feed mode

In this mode, the feed bracket can be moved while the needle stopped.
It is useful for checking the relative positions of the needle and the work clamp.
3063Q
1. Press the SELECT key (1) to change the mode to test feed mode.
* The program number will appear in the program number display (2), and the number of stitches will appear in
the detail display (3).
2. Use the and keys to select the desired program number.
* If an independent program has been selected, the program number changes in the order 1 → 2 → ... → 9 →
1.
* If a cycle program has been selected, the program number changes in the order A1 → A2 → ... → A8 → A1.
However, steps that have not been programmed will be skipped.
3. Press the ENTER key (4) to accept the program number selection.
* The program number display will stop flashing and illuminate steadily.
4. Press the cloth presser switch (5) to lower the work clamp.
5. Press the start switch (6).
* The feed bracket (7) will move to the sewing start position.
6. After releasing the start switch (6), press it once more (or press the
* The feed bracket (7) will move to the next sewing start position.
* The number of stitches in the detail display (3) will decrease by 2.
* To return the feed bracket to the cloth setting position while sewing:
1) Press the EMERGENCY STOP switch (8) and then release it.
2) Press the RESET key (9).
7. If you would like to return the feed bracket (7) to the previous sewing position during test feeding, press the
key.
* The number of stitches in the detail display (3) will increase by 2.
8. When the final stitch is reached, the buzzer will sound.
9. After releasing the start switch (6), press it once more.
* The feed bracket (7) will return to the cloth setting position.
key).
RH-981A
7. SEWING
3142Q
50