Superior BGE18NV Installation And Operation Instructions Manual page 28

FLAME HEIGHT
This function allows you to control the height
of flames through 5 levels (see Figure 63).
Select the manual flame height function by
pressing the MODE button until a flame is
shown in the lower left corner of the display.
Use UP/DOWN arrow button to set desired
flame height for front and rear burner (see
Figure 63). A beep from receiver confirms the
command. When the flame height is set to it's
lowest level it is possible to turn the unit OFF
by pressing the DOWN arrow button again.
If this occurs press the UP arrow button to
relight the unit. A beep from receiver confirms
the command.
ON
Figure 62 - On/Off Setting
28
OPERATION
Continued
ON
www.SuperiorFireplaces.US.com
ON
MINIMUM
Figure 63 - Remote Control Display of
Flame Height Minimum and Maximum
ROOM THERMOSTAT
The remote control can operate as a room
thermostat. The thermostat can be set to a
desired temperature to control the comfort
level in the room.
To activate, press THERMOSTAT button on
remote control (see Figure 61, page 30). The
word ON will appear to the right of tempera-
ture bulb graphic on display (see Figure 64).
Use UP/DOWN arrow button to set desired
room temperature. Control system will cycle
fireplace on or off to maintain selected tem-
perature.
ON
Figure 64 - Room Temperature Setting
ON
MAX
MAXIMUM
Room
Temperature
Set
Temperature
126827-01A