Superior BGE18NV Installation And Operation Instructions Manual page 18

FIBER LOG MODELS
LBG(18,24,30,36)-SM
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place bottom log in center of the base
assembly as shown in Figure 19. The log
must sit flat on the black sheet metal and
behind the left metal tab as shown in figure
19-A.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 19.
Make sure log is completely vertical and
not leaning in toward burner where flame
will touch the log.
3. Position front right log against right side
of grate prongs (see Figure 19).
4. Position front left log against left side of
grate prongs (see Figure 19).
Front Left
Log
Grate
Prongs
Bottom Log
Base Assembly
Figure 19 - Installing Log Set
5. Place middle right log over front right and
bottom logs as shown in Figure 20. Be
sure hole in middle right log seats over
pin in bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 20. Be
sure hole in middle left log seats over pin
in front left log.
18
INSTALLATION
Continued
Rear Log
Front
Right Log
www.SuperiorFireplaces.US.com
Metal Tab
Figure 19-A - Installing Log Set
Middle
Left Log
Pin on Front
Left Log
Figure 20 - Installing Log Set
Left Small
Front Log
Bracket
Left Control
Cover Log
Right Control
Cover Log
Figure 21 - Installing LBG36-SM Model
Control Cover Logs
Ramp
Log
Middle Right Log
Bottom
Log
Bracket
Right Small Front Log
126827-01A