Superior BGE18NV Installation And Operation Instructions Manual page 17

PRESSURE TESTING HEATER GAS
CONNECTIONS
1. Open equipment shutoff valve (see
Figure 15, page 16).
2. Open main gas valve located on or near
gas meter for natural gas or open pro-
pane/LP supply tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from equipment shutoff
valve (see Figure 16 or 17, page 16). Ap-
ply noncorrosive leak detection fluid to all
joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light heater (see Operation, page 28.
Check all other internal joints for leaks.
7. Turn off heater (see To Turn Off Gas to
Appliance, page 29.
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
BGE Series Burner System - Log Compatibility Chart
Burner System Models
BGE18NV, BGE18PV
BGE2436NV, BGE2436PV
126827-01A
INSTALLATION
Continued
Fiber Log Models
LBG18-SM
LBG24-SM
LBG30-SM
LBG36-SM
www.SuperiorFireplaces.US.com
Log Support Brackets
If installing a LBG36-SM, attach log support
brackets before installing logs. These brack-
ets are provided with the BG(E)2436 series
burner systems.
1. Install left bracket to left side of chassis
using 2 screws provided (see Figure 18).
2. Install right bracket to right front of chassis
using 2 screws provided (see Figure 18).
This bracket will also be used as remote
control bracket if remote is installed.
Chassis
Left Log
Support
Bracket
Right Front of Chassis
Figure 18 - Installing Log Support Brackets
SWITCH LOG
Log sets LBG(18,24,30,36)-SM and
LBG(18,24,30)-BM come with a switch log
that is not used with these burner systems.
The switch log can be used as a decorative
log place on the hearth. Do not place on the
burner system.
Concrete Log Models
Right Log
Support
Bracket
LBG18-BM
LBG24-BM
LBG30-BM
17