Superior BGE18NV Installation And Operation Instructions Manual page 22

EMBER PLACEMENT - BGE SERIES
BURNER SYSTEMS
WARNING: Do not use any
other ember material not sup-
plied with this unit.
WARNING: Do not operate unit
without ember material correctly in
place as shown in Figures 49 & 50. Do
NOT place ember material anywhere
else on the unit. Use only ember mate-
rial supplied with unit. Excessive or
incorrectly placed ember material may
produce carbon monoxide or soot.
If replacement embers are needed,
the replacement embers must be
purchased from IHP. See page 38 for
part numbers.
WARNING: All previously ap-
plied loose material must be re-
moved prior to reapplication.
22
INSTALLATION
Continued
www.SuperiorFireplaces.US.com
1. E m b e r C h u n k P l a c e m e n t .
BGE2436 burner systems include three
ember chunks that are designed to fit
over shoulder screws on the ember pan
burner. The bottom of each ember chunk
has a hole for securing the ember chunk
in place when it is placed over a shoulder
screw. Place the ember chunks as shown
in Figure 49 on page 25 by placing the
ember chunk with the number "1" on
the left, "2" in the center, and "3" on the
right. These numbers are embossed on
the back of each piece for identification
purposes. Please note that BGE18 burner
systems do not include ember chunks.
2. Two ember materials are supplied with
this log set. Platinum Bright Embers give
a bright glow appearing as hot coals.
Follow instructions for the ember material
you choose. Should embers need replac-
ing, see Parts, page 42.
Platinum Bright Ember placement. Add
embers to front, flat burner. Gently remove
embers from bag. Separate pieces of
ember material and place on surface of
flat burner just behind horizontal ports as
shown in Figure 50.
Rock Wool placement. Place rock wool
material on front flat burner in areas away
from ports as shown in Figure 51.
3. Add lava rock and small decorative logs
around base of heater if desired. DO NOT
place rock or additional logs on front
burner or on logs. Placing any material
on unit other than ember material on front
burner may result in production of carbon
monoxide or soot. Use lava rock to hide
wires from switch/log to control valve.
Place switch/log so the switch is easy to
access.
T h e
126827-01A