Jumpers - Intel PT-6IBT User Manual

440BX/ZX AT

3.3 JUMPERS

This section will discuss the jumper setting on this mainboard. In order to let you
have better idea of the jumper setting, please see below for the explanation of
jumper settings before you start this section.
open
1-2
A jumper is a set of two, three or more jumper pins which allows users to make
different system configuration by putting the plastic connector plug (mini-jumper)
on it..
The following jumpers which labeled with "optional" means they are optional
on the mainboard and the related components are normally not populated on
the board. In order to make the mainboard works properly, please make sure all
jumper settings are at correct before installing this mainboard.
(A) JP1: Power Supply Selection (optional)
This mainboard provides two power connectors to support both the AT and ATX
Switching Power Supply (SPS). JP1 will be used to select the type of SPS. If you
can not find the JP1 on the mainboard, than the mainboard will detect the type of
SPS automatically.
MAINBOARD
1 1
1
1
2
3
AT SPS
+
-
BAT 1
AWARD BIOS SETUP
short
,
2-3
,
1
JP 1
2
3
ATX SPS
DIMM 3
DIMM 2
DIMM 1
IDE 2
IDE 1 FDC
3-16
1
1