Changing The Jumpers - Intel D845GVSR User Manual

Changing the Jumper
The jumper is a small electrical connector that control circuit or function in your system. Jumper is a
small block on a circuit board with two or more pins emerging from them.
To change a jumper setting, pull the plug off its pins and carefully fit it down onto the pins indicated.
The jumper setting in your computer is preset at the factory; however, you can alter the function
by changing the standard setting:
G
Determines the BIOS Setup program's mode
Function/Mode Jumper Setting
Normal
Configure
Recovery
None
CAUTION
Do not change the jumpers with the power on. Always turn off the computer and unplug the power
cord from the computer before changing the jumpers.
All manuals and user guides at all-guides.com
The BIOS uses current configuration information and passwords for
1-2
3 1
booting.
After the POST runs, Setup runs automatically. The maintenance
2-3
3 1
menu is diplayed.
The BIOS attempts to recover the BIOS configuration. A recovery
3 1
diskette is required.
Configuration
Installing Board Options
3-7