Intel PT-6IBT User Manual page 50

440BX/ZX AT
Standby Mode: ( Default setting: "Disable ")
When enabled and after the set time of system inactivity, the fixed disk drive and the
video would be shut off while all other devices still operate at full speed
Suspend Mode: ( Default setting: "Disable ")
When enabled and after the set time of system inactivity, all devices except the CPU
will be shut off.
HDD Power Down: ( Default setting: "Disable" )
When enabled and after the set time of system inactivity, the hard disk drive will be
powered down while all other devices remain active.
PCI/VGA Act-Monitor: (Default setting: "Enabled" )
When Enabled, any video activity restarts the global timer for Standby mode.
The Choice: Enabled, Disabled
Soft-Off by PWR-BTTN : (Default setting: "Instant-Off.")
When Enabled, turning the system off with the on/off button places the system in a
very low-power-usage state, with only enough circuitry receiving power to detect
power button activity or Resume by Ring activity.
The Choice: Instant-Off, Delay 4 Sec..
CPUFAN Off In Suspend : (Default setting: "Enabled")
This selection allows user to controls the function of the "CN13" ( CPU cooling fan
connector ). When "Enabled" is selected, the CPU cooling fan will stop in Suspend
mode to decrease the system power consumption and noise. When "Disabled" the
CPU cooling fan keeps on working when the system is in Suspend mode.
Resume by Ring or LAN : ( Default setting: "Enabled".)
When "Enabled", you can resume the system from Sleep or Suspend mode by using a
MODEM Ring-in or a LAN signal. In order to make this feature works normally,
there are some requirement need to be noticed, please see Section 2-2 for details.
MAINBOARD
AWARD BIOS SETUP
4-36