Faceplate & Trim Installation - Regency U31 Owners & Installation Manual

INSTALLATION
1) Lay the faceplate panels flat, facedown on something soft
so they don't scratch.
2) a) Take the top faceplate and align the holes in it with
the holes in the side panels. Using the screws
provided, attach from the top of the panel (holes in the
top panel are slightly larger than the holes in the side
panel to facilitate easier installation). See diagram 1.
b) 4"(102mm) Hearth Trim. Attach the Hearth Trim to the
bottom of the faceplate side panels with the screws
provided. See diagram 1.
Hint: Don't tighten the screws down completely at this
point, do a trial fit to the unit. Make any necessary adjust-
ments and when it fits properly then tighten down the
screws.
Diagram 1: Faceplate Assembly
3) Using the trim clips provided, join the left side trim (with
the ON/OFF switch) to the top trim. See diagram 2.
Connect the right side trim to the top trim.
Diagram 2: Trim Assembly
10
FACEPLATE & TRIM INSTALLATION
Trim
Clips
4) Place the trim on the assembled faceplate panels, align-
ing the wire connections from the switches with the notch
on the left side panel.
5) Connect the fan switch wires by taking the black and red
wires with the male ends (in the grey harness) and
connect them with the wire connectors from the fan speed
control.
6) Connect the ON/OFF switch wires by taking the black and
red wires with the female ends and connect them to the
ON/OFF switch.
7) Install these wires in the clips on the left faceplate to
ensure they dont touch the insert. See diagram 3.
Wires to
On/Off
Switch
For Gas
Connection
Diagram 3
8) The power cord should be run behind the faceplate panel
from the U31/I31 to electrical outlet box.
U31/I31 Gas Insert Zero Clearance Kit
ON/OFF
Switch
Fan Speed
Switch
(Rear View)
Self-adhesive
Wire Clip
Wires to
Fan Switch
Connectors
POWER CORD (3ft)