Kit Assembly - Regency U31 Owners & Installation Manual

1) Using the screws provided, attach left and right sides to
the rear panel. Side flanges go on the outside. See
diagram 1.
2) Install floor. All floor flanges go on the inside. See
diagram 1.
U31/I31 Gas Insert Zero Clearance Kit

KIT ASSEMBLY

Diagram 1
Diagram 3
3) Install top assembly. Make sure top rear flange is on the
outside of the back panel. Top side flanges go on the
inside.
4) Install top front standoff assembly, with the drywall stand-
off angle facing forward. See diagram 1.
5) Move Zero Clearance Assembly into final position and
attach to framing. See diagram 3.
6) Attach 4"(100mm) - "B" vent adapter. See Venting.
Note:
INSTALLATION
Top insulation protrudes about
1"(25mm) in order to assure a
tight seal when faceplate is
installed. Leakage in this area
will result in possible overheat-
ing of the finishing material im-
mediately above the frame. See
diagram 1.
Diagram 2
7