10) Attach the brass trim to the faceplate by drilling
a 1/8" (3mm) hole through the faceplate using
the hole in the trim as a guide. Fasten the trim
to the faceplate panels using the plated screws.
#10 x1/2". See diagram 6 detail 'C'.
11) Attach the faceplate panels to the insert body
using the 4 remaining black screws. See dia-
gram 6 detail 'A'.
12) Slide the Top Deflector into the two brackets
under the fireplace body top. Diagram 7.
Top Deflector
Diagram 7: Slide Top Deflector into brackets.
After Deflector is installed
13) Push the logo plate into the two holes in the bottom left
corner of the faceplate.
Note:
If ashlip is required for safety clearance (see pg. 5) then attach to stove unit using the 2 lower screw holes on the
face of the stove unit (see diagram 6 detail 'B').
Note:
This faceplate with Hearth Trim Assembly replaces the standard Assembly as shown in the U31/I31 Installation
Manual.
Install finished facing surface of 1/2"(13mm) thickness on framing. Drywall 1/2" (13 mm) thick can extend flush with the
appliance on all three sides of the front face. The height at which the mantel must be installed above the top louver depends
on the depth of the mantel. If the mantel is to be painted, use a heat resistant paint to prevent discolouration.
U31/I31 Gas Insert Zero Clearance Kit
FINISHED FACING NOTES
INSTALLATION
Diagram 6
11