Table of Contents
Advertisement
Installation in front panels
Step
1
Working from the front, insert the MP270 in the mounting cut-out provided.
Make sure the unit cannot drop out of the front panel before it has been secured.
2
Insert the hooks of the ten screw-type clamps enclosed in the corresponding
recesses in the housing of MP270.
The individual positions are indicated in the figure by means of arrows.
3
Tighten the MP270 to the front panel, from the rear, using a hexagonal
socket-head screw key.
Note
MP270 Equipment Manual
Release 01/99
Make sure the seal is seated correctly against the front panel.
Do not overtighten the screws to avoid damage.
Action
Front panel
Installation
7-3
Hide quick links:
Advertisement
Table of Contents
