Unpacking; To Install Handles - Craftsman 919.195400 Operator's Manual

Unpacking

1. Remove unit from carton and discard all packag-
ing. NOTE: Save all parts bags.
To Install Handle
clearance, stability, or support for pulling
the unit up and down stairs or steps. The
unit must be lifted or pushed up a ramp.
Do not lift the unit be the manifold assem-
bly, the unit could be damaged.
1. To make installation easier, submerge handle grip
into warm soapy water. Remove handle grip from
soapy water and slide onto handle.
2. Insert the open end of the handle under the sad-
dle. Before attaching handle, you may have to pull
the open ends of the handle apart so they fit
tightly against the side of the saddle. Looking in
from the open end of the saddle, position the
handle toward the two bent tabs, on the inside
walls of the saddle.
3. Slowly push the open ends of the handle onto
both tabs at the same time. Continue pushing the
handle into the saddle until the holes on the side
of the saddle and handle are in line.
D22171
The wheels and handle
do not provide adequate
4. Guide the straight end of each retaining clip
through the saddle hole and both handle holes.
5. Rotate each retaining clip clockwise and press
down until it snaps into place over the handle.
6. If the handle has excessive movement, it is
improperly installed. Check the following.
A. Are both tabs inside the handle (Step #3)?
B. Does each clip pass through both the saddle
and handle (Step #4)?
8 - ENG