To Replace Regulator; To Replace Belt - Craftsman 919.195400 Operator's Manual

To Replace Regulator

1. Release all air pressure from air tank. See "To
Drain Tank" in the Maintenance section.
2. Unplug outfit.
3. Remove the regulator ring and remove the con-
sole cover.
Regulator
Ring
4. Using an adjustable wrench loosen pressure relief
tube nut at air tank and pressure switch.
5. Lift retaining clip from handle and remove handle.
Retaining clip
6. Using an adjustable wrench, rotate the pressure
switch assembly as shown.
Regulator
Outlet
Pressure
Gauge
7. Remove the outlet pressure gauge, tank pressure
gauge, and quick connect (if equipped) from the
regulator.
8. Remove the regulator.
9. Apply pipe sealant tape to the nipple.
10. Assemble the regulator and orient as shown.
NOTE: Arrow indicates flow
of air. Make sure it is point-
ing in the direction of air
flow.
D22171
Console Cover
Handle
Tank
Pressure
Gauge
Quick
Connect
Regulator
Arrow
16 - ENG
11. Reapply pipe sealant to outlet pressure gauge,
tank pressure gauge, and quick connect.
12. Reassemble outlet pressure gauge,tank pressure
gauge, and quick connect. Orient outlet pressure
gauge and tank pressure gauge to read correctly.
Tighten quick connect with wrench.
13. Rotate pressure switch assemble into correct
position.
14. Replace console cover and regulator ring.
15. Replace handle. Refer to Handle Assembly para-
graph in the Assembly section.

To Replace Belt

body or loose items get caught in moving
parts. Never operate the unit with the belt
guard removed. The belt guard should be
removed only when the compresor is
unplugged.
1. Unplug compressor.
2. Remove the front of the belt guard by disengaging
the snaps. Insert a flat bladed screwdriver at each
snap location and pry the beltguard apart.
3. Loosen the wing nut on hold down plate and tilt
motor to allow for easy removal or installation of
the belt.
Wing Nut
4. Remove belt.
5. Replace belt. NOTE: The belt must be centered
over the grooves on the flywheel and motor pul-
ley.
6. Turn the wing nut on the hold down plate until it
makes contact with the washer, plus one addition-
al turn.
7. Replace the belt guard.
Serious injury or damage
may occur if parts of the
Belt Guard