Unpacking; Assemble Handle; Assemble Wheels; Assemble Rubber Feet - Craftsman 919.167790 Operator's Manual

Unpacking
1. Remove unit from carton and discard all packag-
ing. NOTE: Save all parts bags.
Assemble Handle
1. Insert the handle inside the compressor saddle
and line up the two bolt holes on each side.
2. Install the four screws, two on each side.
3. Tighten securely.
Screw
Assemble Wheels
.
it will be necessary to brace
or support one side of the
outfit when installing the wheels because the
compressor will have a tendency to tip.
Attach wheels with shoulder bolts and nuts as
shown.
2. Tighten securely. NOTE: The outfit will sit level if
the wheels are properly installed.
I___ The wheels and handle
do not provide adequate
clearance, stability or support for pulling
the unit up and down stairs or steps. The
unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1. Attach rubber feet with the screws, washers and
nuts provided as shown in previous figure.
2. Tighten securely.
'_ Flat Washer
i_-_ Rubber Foot
Screw
Shoulder
Bolt
D24305 8- ENG