Unpacking; Assemble Wheels; Assemble Rubber Feet; Assemble Quick Conncect - Craftsman 919.167780 Operator's Manual

Unpacking
1. Remove all packaging leaving the air compressor
on the pallet.
2. Remove and discard the (4) screws holding the air
compressor to the pallet.
2. Tighten securely. NOTE: The outfit will sit level if
the wheels are properly installed.
The wheels and handle
do not provide adequate
clearance, stability or support for pulling
the unit up and down stairs or steps. The
unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1. Attach rubber feet with the screws provided as
shown in previous figure.
2. Tighten securely.
3.
It may be necessary to
brace or support one
side of the air compressor when removing
the pallet because the air compressor will
have a tendency to tip.
Carefully remove the air compressor from the pal-
let.
Assemble Wheels
1.
It will be necessary to brace
or support one side of the
outfit when installing the wheels because the
compressor will have a tendency to tip.
Attach wheels with shoulder bolts and nuts as
shown.
Rubber Feet
Wheel
Shoulder Belt
D22130 8-ENG