Table of Contents
Advertisement
Available languages
Available languages
Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSlG:
Pounds per square inch gauge; a unit of meas-
ure of pressure.
ASME:
American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.
Code Certification:
Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent safety
laboratories and meet the applicable
Underwriters
Laboratories Standards for Safety.
Cut-In Pressure:
While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to a certain low
level the motor will restart automatically.
The low
pressure at which the motor automatically
restarts is
called "cut-in" pressure.
Cut-Out
Pressure:
When an air compressor
is
turned on and begins to run, air pressure in the air
tank begins to build.
It builds to a certain high pres-
sure before the motor automatically
shuts off - pro-
tecting your air tank from pressure higher than its
capacity.
The high pressure at which the motor shuts
off is called "cut-out"
pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
The accessories
and tools are available
through
the current
Power and Hand Tool Catalog
or full-line
Sears
stores.
Accessories
•
In Line Filter
•
Tire Air Chuck
•
Quick Connector Sets
(various sizes)
•
Air Pressure Regulators
•
Oil Fog Lubricators
•
Air Hose:
1/4", 3/8" OR 1/2" I.D.
in various lengths
Refer to the selection chart located on the unit to select the tools this unit is capable of powering.
Contents
of Carton
1 - Air Compressor
1 - Parts bag containing:
1 - Operator's Manual
1 - Parts Manual
4 - 5/8" Washers
Tools Required for Assembly
1 - 9/16" socket or open end wrench
Electric drill
Unpacking
Remove all packaging.
It may be necessary to
brace or support one side
of the outfit when removing the pallet
because the air compressor will have a
tendency to tip.
2.
Remove and discard the (4) screws and washers
holding the compressor to the pallet.
3.
With the help of another person carefully remove
air compressor from pallet and place on a level
surface.
7 - ENG
D21879
Hide quick links:
Advertisement
Table of Contents
