maIntenance
cleanInG the dust chute
Clean the dust chute periodically to remove sawdust.
Using a 4 mm hex key, remove the screws that secure
the back panel.
Inspect the dust chute and attached dust collection
devices to clear away sawdust or other debris.
Replace the back panel.
tO RemOVe and chanGe belt
See Figure 79.
Lower the saw blade.
Using a 4 mm hex key, remove the screws that secure
the back panel.
With a 6 mm hex key, loosen the bolt above and to the
right of the belt.
Pull the belt off the pulleys.
Insert a long flat blade screwdriver as shown.
Holding the screwdriver in place, pull the new belt over
both pulleys, making sure it is properly placed.
Remove the screwdriver.
Tighten the bolt.
50
bOLt
HEx
KEy
SCREWDRIVER
Fig. 79