RIDGID R4512 Operator's Manual page 19

ASSEMBLY
ASSEMBLING THE LEG STANd oNTo THE
SAw CABINET
See Figures 13 - 14.
wARNING:
Only install the dust chute when using a four inch
dust collection system. Failure to heed this warning
could result in serious personal injury or death.
Clean saw dust from the cabinet regularly.
NoTE: Make sure the foam block has been removed before
installing the dust chute.
Place the dust chute on top of the saw cabinet. The word

"FRONT" and the arrow should align with front panel of
the saw and the registration ridges should align with the
grooves.
Place the assembled leg stand over the dust chute as

shown.
Locate the following from the small fastener pack:

4 Flat washers
4 Lock washers
4 Bolts
Slide a lock washer and a flat washer over each bolt.

Thread a bolt into each of the 4 holes at the corners of

the leg stand.
Using a 6mm hex key, securely tighten the bolts.

ASSEMBLING THE CASTER SET
See Figures 15 - 16.
Remove the bolts and nuts from the 4 casters.
NoTE: Use a 13 mm wrench and a 14 mm wrench for the
nuts and the bolts.
Attach the casters to the axles by sliding the bolts through

the holes and placing the nut over the bolt. Securely
tighten each nut.
Remove the center bolt and nut from the rear and front

axle assemblies.
NoTE: Use a 6 mm hex wrench to hold the bolt and a
13 mm wrench to loosen the nut.
Position the front and rear axles as shown.

Attach the center support to the front axle assembly.

Slide the bolt through the hole in the axle center piece
and thread the nut over the bolt. Tighten the nut.
Attach the center support to the rear axle.

Dust chute
bOlt
lOcK
washer
flat
washer
bOlt
Nut
Nut
bOlt
rear aXle
assembly
19
Fig. 13
Fig. 14
caster
ceNter
Nut aND
bOlt
Fig. 15
ceNter
suPPOrt
frONt aXle
assembly
Nut
bOlt
Fig. 16